Hard disks, solid state drives

HDD, SSDForum → The controller is heating up (WD1200)

The controller is heating up (WD1200)

Pages: 1
26.01.2018 15:49:00
Hello, there is a screw WD Caviar 1200, when turned on the screw emits a long squeaking, while one of the chips (chip) is heated very much. A couple of times the screw was detected in the bios after removing the controller, cleaned with alcohol, stopped displaying. Will replacement of the controller or the problem in another help?

The screw of course with the broken sectors was.
Photo attached:
http: // funkyimg. com / i / 2BCxw. jpg
http: // funkyimg. com / i / 2BCxv. jpg
http: // funkyimg. com / i / 2BCxu. jpg
26.01.2018 16:08:00
It's Hawk and the boards on them rot. Replacement does not hurt.
I would immediately check it on the same disk.
But you are more likely to turn into a misfire.
And it's basking on the fact that it can not keep its head above the track normally.
26.01.2018 17:31:00
Such will approach or suit to mine? the version is the same Board 2061-701335 b00 AF, only the one for the version 2500JS

https: // www. harddrivesforsale. com / boards / wd2500js-41 ... 01335-b00-af. html
26.01.2018 17:35:00

Suitable.
701335 there is only one configuration.
You can not look at other figures, they are not related to the configuration.
A ROM must be transferred to any, there are unique adaptations.
Even if the ROM version is the same

For anyone, it's easier to get to the master who deals with the HDD and check the card from it.
And a hermetic block for one.
And decide whether to buy a new board.
The probability that the sheathed unit is covered is much higher than the failure of the board.
The total flow for board failures is less than 5%.
And then most often they are killed by the users themselves, when they punch hard where and how horrible, if the disc starts to crash and hang.

28.01.2018 10:28:00

This is Hawk and the boards on them rot. Replacement does not hurt
Strange, I have a similar board, only from 2500JS, as the author found, in a normal state, even the contacts did not change the hue much, unfortunately started to pour in after 9 years of work.
28.01.2018 10:39:00
Evgeniy Golikov
From climatic conditions, it is more likely to depend on whether it is rotting or not.
They are not all the same, they fail.
I have four live and a dozen donors with failures, but with live heads and boards. But there are only one spare boards. Usually a turn. There are a lot of fees, but the junk banks.
28.01.2018 12:17:00


And what do you need - repair or retrieve it?
28.01.2018 21:51:00
Infu basic turned out to get, I wanted to resurrect it and screw it, 7 years as linux on it hung
16.02.2018 10:37:00
:

Suitable.
701335 there is only one configuration.
You can not look at other figures, they are not related to the configuration.
A ROM must be transferred to any, there are unique adaptations.
Even if the ROM version of the same



Addition of 26. 01. 2018 19: 38:

On any easier to get to the master, who is engaged in HDD and check his charge.
And herblock for one.
And decide whether to buy a new board.
The probability that the hermetic unit is covered is much higher than the failure of the board.
The total flow for board failures is less than 5%.
And then most often they are killed by the users themselves, when they punch hard where and how horrible, if the disc starts to crash and hang.
Yes, apparently the reason is different, the controller came in, installed and does not display the screw. I will look for a master in my city
16.02.2018 11:04:00

came to the controller, installed and does not display the screw.
The ROM (U12) must be transferred from the old card.
But it sometimes happens to them in the process.
16.02.2018 15:24:00

I will look for a wizard in my city
can someone agree with him to fiddle less than sell the same beau?
16.02.2018 15:37:00


So the master will most likely offer another b. y
Pages: 1
HDD, SSDForum → The controller is heating up (WD1200)

The controller is heating up (WD1200)