Hard disks, solid state drives

HDD, SSDForum → How to restore the firmware from Maxtor (+)?

How to restore the firmware from Maxtor (+)?

Pages: 1
21.03.2003 19:47:00
There are a bunch of thin Maxtor, we all have the same problem. Instead, the name of the model directly in the BIOS-e defined as Maxtor ATHENA, Maxtor ARES C64K, Maxtor N40P.
As I understand, all service information is damaged. E. Microcode. Can I recover it at home? If not, where can be in Moscow for a small cost to do that?
22.03.2003 6:49:00
And what is written on the Powermax utility-type products?
22.03.2003 9:14:00
The Powermax screws do not determined. Although the ports (eg prog HDD_UTIL) these screws visible.
22.03.2003 10:19:00
In principle, these can lift screws if they are not "noise". But very few statistics on their subsequent behavior. It may happen that the system area will fly again in a few days. Here it is necessary to dig or cause, or wait for the official update from Maxtor.
22.03.2003 18:19:00

or wait for the official update from Maxtor.
Is there hope?
23.03.2003 11:18:00

And they still have to do, and if the remaining screws will carry the roof? Quantum and Fujitsu have already finished badly that it became known to them all.
All these troubles from cheaper products. Save on everything: on materials, components, technologies (remember the washing of flux at Fujiko!).

microcode is also an essential part of a screw, and its development (and "running"), is time consuming. But competitors do not wait! ! ! So it turns out that on the market there are screws in the semi-raw form. With its embedded glitches in operation. Theoretically, such a screw can run long. But certain conditions screw himself something rewrites (or NEdopisyvaet ) in the service area. Such conditions may include: poor diet, the occurrence of certain events in the SMART-statistics, some clever type of surface defect (for REMAP of the service area is updated), or just hang microcontroller due to a stack overflow or illegal instruction
screw himself makes harakiri, and he refuses to come out of the damaged system area in readiness. The task of developers is precisely to determine the cause and plug the hole microcode update. Perhaps they are already engaged in this.
23.03.2003 14:43:00
Read on
http: // maysoft. com. ua / article about Maxtor (something that you already told ) There's also you can see the list of repairers that can help you.
24.03.2003 12:01:00
quote:
:
There's also you can see the list of repairers that can help you.
Not all of that list will .
24.03.2003 21:05:00

Well, he will check And no one else
Pages: 1
HDD, SSDForum → How to restore the firmware from Maxtor (+)?

How to restore the firmware from Maxtor (+)?